The DigiRail-VA is
the latest addition to the successful and cost effective DigiRail family.
Specifically designed for single phase AC power analysis applications, it is
able to measure the most important AC signals and retransmit them in both
analog and digital ways.
Features and Specifications:
- Voltage: 0 to 300 Vac (True-RMS)
- Current: 0 to 5 Aac (True-RMS) - It
does allow use of CTs for higher current applications
- Active Power
- Reactive power
- Apparent power
- Frequency: 45 to 65 Hz
- Power Factor: 0.00 to 1.00
- Compact, DIN rail
mounting unit featuring RS485 /Modbus-RTU interface as standard (baud rate from
1200 to 115200, configurable parity) allowing easy access to all the parameters
by any SCADA package or Modbus capable PLC
- Analog retransmission (user selectable
4-20mA and/or 0-10V – all by software; no jumpers)
- Any one of the values can be re-scaled
and retransmitted using the on-board analog outputs
- Full 2500 Vrms isolation between the
high voltage/current inputs and the low voltage signals
- Protects your upstream instruments
- High accuracy measurements
- Accuracy of Voltage, Current &
Power readings over RS485 is +/- 0.25% and +/- 0.5% over the Analog
Retransmission
- Accuracy of the Frequency and Power
Factor readings over RS485 is +/- 0.5% and +/- 1% over the Analog
Retransmission (Please note, however, that the DigiRail-VA is not intended for
and should not be used for commercial energy metering applications)
- Wide Ranging 10-40Vdc power supply
requiring just 2.5 W. It is suitable for most standard low voltage industrial
supplies.
