The Scigiene GEN 2 wireless control units contain two separate relay switches allowing for individual control through the Scigiene Premiere online sensors portal. The GEN 2 control unit relays can be switched on/off manually through the software or automatically by any wireless sensor notification assigned to a single sensor or group of sensors when a specified condition is detected. Four LED indicators let the user know if the device is powered on, communicating with the online system and the status of each relay. The unit’s two relays can also be controlled automatically by any wireless sensor or group of sensors. Automatic relay switching can be triggered by setting the control parameters in a sensor notification from the system. The user can set the default state of each relay to on or off and user defined messages from sensors will cause the relay unit to switch to the non-default state. The relay switches back to its default state when the condition is no longer met.
Example Use: If a water sensor detects water at a certain level in a sump pit, the relay will switch ON, activating the pump. When water is no longer detected, the relay will switch OFF, deactivating the pump motor.
Features:
Specifications:
| Initial Contact Resistance | Max. 100 mΩ |
| Max Switching Power (resistive load) | 2500VA 150W (NO) 1662VA 150W (NC) |
| Max Switching Voltage | 250 VAC, 100 VDC (0.5A) |
| Max Switching Current | 10A (AC), 5A (DC) |
| Nominal Operating Power | 360 mW |
| Operate Time (at nominal voltage / 20°C) | Max 10 ms |
| Release Time (at nominal voltage / 20°C) | Max 10 ms |
| Max Operating Speed | 20 times/min (at nominal switching capacity) |
| Number of Relays | 2 (individually controlled) |
| Control Activation |
|
| Input Power | 5.5 VDC @ 900 mA |
| Antenna | Connector: SMA Gain (dBi): 3.0 |
| Indicator Lights | Four LED indicators
|
| Enclosure | ABS Plastic UL94V-0 flame rating |
| Operating Temperature | -40° to +85°C (-40° to +185°F) |
